Microhard Systems VIP4G Instrukcja Instalacji Pobierz pdf (Strona 111)

Appendix C: Firmware Upgrade / Recovery

Package upgrade or recovery upgrade can be used. Package upgrade will keep settings intact.

Recovery upgrade will upgrade a unit completely, it can also be used to recovery from a cor-

rupted system.

Package upgrade (*.pkg)

Ø Download upgrade package and put it into a known directory;

Ø Start up a command line window from the system;

Ø Change current directory to where the package file is located;

Ø Start a FTP session to the unit;

Ø Provide proper user name and password to login; (username: upgrade; passwd: admin)

Ø Change transfer protocol to *BINARY* mode;

Ø Push package upgrade file into the system with “put” command;

Ø Package upgrade takes up to 2 minutes to complete.

Recovery upgrade (*.img)

Ø Download recovery image and save it into a known directory;

Ø Start up a command line window from the system;

Ø Change current directory to where the package file is located;

Ø Cycle power on the unit with CFG button pressed and held down until “RSSIs, TX and RX”

LED is observed in flash mode;

Ø Start a FTP session to IP address *192.168.1.39 from LAN port*;

Ø Provide proper user name and password to login (username: upgrade; passwd: admin);

Ø Change transfer protocol to *BINARY* mode;

Ø Push package upgrade file into the system with “put” command;

Ø Package upgrade takes more than 2 minutes to complete.

Ø The unit automatically reboots after the recovery procedure is completed

1 2 ... 106 107 108 109 110 111 112

Brak uwag

Microhard Systems VIP4G Instrukcja Instalacji Strona 111